#I68 waterroof series

#I68 waterroof series

K Series Push Pull Waterproof Connectors- The Ultimate FAQ Guide You can choose different waterproof connectors for your outdoor electrical connection needs. INTE-AUTO have an IP66 to IP68 rating and are great alternatives to existing push pull waterproof connectors from other brands. Our advanced precision circular waterproof connectors have a rugged outer shell design and high mating capability to meet harsh environmental conditions. Your Reliable IP68 Waterproof Connectors Supplier INT-ZEG.1K.316.CLN: 1k 16 pin IP68 back Panel Mounted Receptacle connector, G key(alpha=0), PPS insulator, female PCB contacts, two fixed nuts. INT-ZGG.0K.305.CLN: 0K 5 pins front Panel Mount Receptacle, keying system for connector alignment, PPS insulator, female PCB contacts for PCB board, fixed nut.

INT-DHG.3K.302.CLLDXXZ: 3K series 2 pin connector waterproof cable mount receptacle, G key for connector blind mating, PPS insulator, female solder contacts, cable collet, ruggedized design outer shell brass plated natural chrome or black chrome. INT-DHG.0K.307.CLLDXX: 0K series 7 pin connector female waterproof connectors, 1 key(alpha=0), PPS insulator, solder contacts for custom wire harness assembly, cable collet, rugged outer shell plated natural chrome. Inline Waterproof Connector with Cable Collet INT-TGG.2K.326.CLADXXZ: 2K series, 26 pin IP68 connectors waterproof plug, Standard G key, PPS insulator, male soldering contacts for custom cable assembly, cable collet, brass outer shell plated pearl chrome, nut for cable bend relief fitting INT-TGG.1K.302.CLADXX: 1K series 2 pin straight plug, 1 key(alpha=0), PPS insulator, male soldering contacts gold plated, cable collet, brass outer shell plated pearl chrome, black chrome is available.

Slide the bend relief onto the collet nut.

Screw the collet nut with the flat spanner tools.

Ensure the internal components do not rotate in the shell.

Slide the plug shell over the insulator assembly making sure that the key on the insert carrier goes into the keyway.

Place the split insert carrier and key on the insulator.

Verify that insulator and insulation remain clean, control that your assembly has a generally good aspect.Solder the first wire to the solder bucket and repeat the action for the other wires.Place the insulator in the soldering check, place the first individual wire and get ready to solder with your preheated solder iron, and arrange the conductors according to the insulator.Cut the remaining filler and start stripping the individual wires.In case of a screened cable, fold the screen back over the edge of the collet.

Slide in the bend relief first, then place the nut and collet on the cable.

Cut the cable at the appropriate length.

Check all the components: outer shell, split insert carrier, earthing cone, gasket, collet, nut, insulator, strain relief.

K Series Waterproof Connector Assembly Instruction:

Waterproof Aviation Connector Menu Toggle.